Railway Sheet 01
-
1) Question.
On B.G. tracks the distance of outer signal from station limit is kept
Answer. -
2) Question.
In Indian railways, the ratio of axle load and weight of rail, is
Answer. -
3) Question.
In India the rails are manufactured by
Answer. -
4) Question.
To avoid the damage of nose of crossing, the wing rails are ramped so that nose of crossing remains at a lower level by
Answer. -
5) Question.
Smith diamond is provided if the angle of diamond is less than
Answer. -
6) Question.
The arrangement of rails which permit trans to cross another track and also to divert to the other track, is called
Answer. -
7) Question.
According to Railway Board, no diamond crossing should be flatter than
Answer. -
8) Question.
The place where a railway line and a road cross each other at the same level, is known as
Answer. -
9) Question.
In Indian railways, plate laying is usually done by
Answer. -
10) Question.
Track construction involves preparation of
Answer. -
11) Question.
Head width of 52 kg rail section is
Answer. -
12) Question.
Tensile strength of steel used in rails should not be less than
Answer. -
13) Question.
52 kg rails are mostly used in
Answer. -
14) Question.
The cross-sectional area of 52 kg flat-footed rail is
Answer. -
15) Question.
The purpose of providing fillet in a rail section is to
Answer. -
16) Question.
Largest percentage of material in the rail is in its
Answer. -
17) Question.
Largest dimension of a rail is its
Answer. -
18) Question.
The standard length of rail for Broad Gauge and Metre Gauge are respectively
Answer. -
19) Question.
Two important constituents in the compostion of steel used for rail are
Answer. -
20) Question.
The rail is designated by its
Answer.
