Steel Design Sheet 30
-
1) Question.
The design of an eccetrically loaded column should be revised, if
[= Allowable working stress in compression in the member subjected to axial load only, = Calculated average axial compression stress, = Maximum allowable bending compressive stress on the extreme fibre, and = Calculated bending stress in the extreme fibre]
Answer. -
2) Question.
An eccentricity loaded column is subjected to
Answer. -
3) Question.
The batten plates used to connect the components of built-up column are designed to resist
Answer. -
4) Question.
A joint in the kength of a column is known as
Answer. -
5) Question.
When the ends of a column are cut by ordinary method
Answer. -
6) Question.
When the ends of the column are faced for bearing over the whole area, the rivets essential to hold the connected members are designed for..... axial load and other forces acting on the column.
Answer. -
7) Question.
If the overall length of a combined footing is L, area of base of footing is A, and the distance between thr centre of base and the centre of gravity of the base is d, then the smaller width (c) for the trapezoidal base of the footing is equal to
Answer. -
8) Question.
In combined footing, the shape for the base of footing should be.... to support two equal column loads.
Answer. -
9) Question.
A structural member subjected to tensile force in the direction parallel to its longitudinal axis, is called
Answer. -
10) Question.
The wire ropes
Answer.
